桦木胶合板的安装步骤
1.Measure the wall carefully and plan
out how the panels will be
arranged.
2.If the arrangement of the panels
results in the need to cut a panel,
cut away from the starting or ending
panel or from both as much
as needed.Also cut holes
for outlets and switches if
required.When you machine
the board,you should always
make sure that there will
be no damage to the treated
surface.For example,when
you use a circular saw on the
board the treated surface
should be facing down.
3.Fasten the panels on a
flat wall.If necessary,the wall
must be made flat through the
use studding or using furring
strips and shims.
4.Fasten horizontal laths on
the frame or walls.The should
be min.20mm(13/16”)thick and50mm (2”)wide.The panels can be installed either horizontally or
vertically.When laying the
panels horizontally,the
spacing between the laths
should be454mm
(177/8”).When laying
the panels vertically,the
spacing between the laths
should be732mm
(2813/16”)
5.Nail,screw or staple the panel onto the horizontal lath.The
proper fastening point
is about100(3/8”)from
the edge of the panel
tongue.The head of the
nail or screw must be
countersunk into the wood
so that it’s easy to fasten
the next interlocking
panel.If you usescrews
we recommend that you
use a screw twister and3x25mm(1/8”x 1”)countersunk screws.If you use nails we recommend that you use a nail gun or industrial staple gun in order to avoid hammering the wood surface.
6.Slide the panel
carefully into the
previous.In order to
secure a tight joint,you
can lightly knock on the
edge with a hammer,
using a wooden block to
protect the edge.This
way you can keep the
gap between the panels
exactly4mm(3/16”)wide
and the nail or screw heads will be hidden.
7.In the edges and corners
where you have to cut the
panels,you must fasten
the panel through its outer surface.Tou can make a neat
by a mitre cut
joint or trim it with wood or mouldings.
8.Possible fixing marks on
the edges and corners can be trimmed out with wood or
pre-fabricated mouldings.

更多推荐

胶合板,步骤,桦木,安装